What would you do?
Posted: Tue Nov 15, 2022 7:06 am
I used Eduard seat harness set, which is pre-painted photo etched, and the metal was quite stiff and now one of the harness straps, on both seats, has pinged up and even pulled some of the black paint away from the seat.
I had to add a lot of superglue between the bodyshell and chassis as it was a poor fit, and so cannot take it apart to carry out a repair.
It's seriously bugging me what to do.
As I see it my options are:
1. Leave it as it is.
2. Spend many hours and lots of de-bonder to get the bodyshell off (which might not work).
3. Use tinting film and cut pieces to shape for the side windows so the belts cannot be seen (but a lot of work went into the dash so that would also not be able to be seen).
4. Somehow cut both side windows out to effect a repair, but I am worried about making a mess of it.
Any ideas would be gratefully received.
I had to add a lot of superglue between the bodyshell and chassis as it was a poor fit, and so cannot take it apart to carry out a repair.
It's seriously bugging me what to do.
As I see it my options are:
1. Leave it as it is.
2. Spend many hours and lots of de-bonder to get the bodyshell off (which might not work).
3. Use tinting film and cut pieces to shape for the side windows so the belts cannot be seen (but a lot of work went into the dash so that would also not be able to be seen).
4. Somehow cut both side windows out to effect a repair, but I am worried about making a mess of it.
Any ideas would be gratefully received.