Ferrari 312 B3 1973 1:12

[gp-models]

Still looking great, i like the idea of stratch building this car based on all materials everyone can buy on it`s own and showing up with such clean work, brilliant!

[ferrarissimus]

Scratchbuiling is an affair of try and error and revision. So I had two or three attempts building some parts for this car. This is for the front bulkhead too.
I realized that the front bulkhead and the triangular suspension supports are not in one piece. Hence I cut the triangular support, made a new reduced bulkhead from alu sheet with opening for the brake cylinders and the steering rack.

[SanMarino]

Masterful workmanship and build!!!

[nsdias]

incredible

[ferrarissimus]

Some new parts for the rack and pinion drive and the anti roll bar.

[gp-models]

That`s looking fantastic, brilliant skills!

[Belugawrx]

Great to see updates on the 312 B3, and showing your steps really educates...thank you
Cheers

[Dede]

Incredible work, really amazing build.

[ferrarissimus]

Made some progress with the front suspension.

rear and front lower wishbones(1,3 mm brass tubes)

front rocker arms, made from styrene sheets, then made silicon forms and resin cast. Bracket for the rear support bar is made from alu sheet.

front suspension parts. Shock absorber is turned from alu.

added the torsion bar to the front bulkhead and brake lines

temporary fixed front suspension

[gp-models]

Amazing work, great skills!