guys,
thx for the positive feedback on the dash gauge decals. I'm happy that they are received well.
Also, there are some new items i'm working on that i want to share.
1. 1/12 P34 Six Wheeler Photo Etch detail sheet
Containing all obvious parts, but also carries front & rear wings & wing support, and radiator etch has finest detail available. Sheets are now @ etchers, i expect to have them ready for sale end of february.
2. Finally, test casting for the 1/12 aston martin project 218 engine have returned from casters.
Waaw & waaw again. So proud! Excellent castings, minimal flash,perfect fit. Yeay.
Pictures are from main parts, dry fit (no glue, no photoshop).
Ok, now for another 8-12 weeks waiting before final parts arrive? I hope not...
3. Currently in development: 1/12 decal sheet to fit protar's Alfa Romeo 179. The sheet will contain all logo's needed to finish the all red car (no cigarette sponsor), the ciggie sponsored car & the car wearing black stripes in stead of ciggie logos.
Sheets are still on drawing table, as i still need to determine 2 logos, but should be finished 1st week of Januar. Ready for sale 8-12 weeks later
4. I received my personal 3D lithographic printer. I tried to draw 3D part for test printing, but had difficulties using the software since it was already few months ago that i worked with it. grrrr. Will be a difficult start to get familiar with it again.
So, to test print, i used the alternator & a V-string disk from my aston martin project. The alternator is printed in both .1 & .025mm resolution. I forgot which is which. Also, the missing part broke off while transporting the parts: it printed perfect (.5mm thickness). The alternator has diameter of approx 11mm. Support structures still need to be removed.
wim