Well, this build is becoming a lot more complicated then I thought
First, I made the two side "bulges" that are located just in front of the windscreen :
The bulges appeared to be OK, but after looking at the pictures of the real Beurlys, I noticed that the shape not correct. They're not long enough and to narrow :
But there was no way that I could make these bulges bigger without some more rebuilding of the hood. First I added a couple of plastic pieces to the rear of the bonnet, to make it longer, and change the angle of the base that will hold the windscreen :
After :
Before :
And I had to change the holes for the louvres for the third time !! They will be moved another 2-3 millimeters to the sides of the bonnet :
And this is how they look now :
After the removal of the center square piece, I'm left with four holes on each side. New center pieces will be made, to change them into eight holes.
Till next time
Pascal