Very slow progress.
TEST FITTING is very important. I found that the position of the Engine Block is too high. It could not fit with other part at all. So, in order to LOW DOWN the Engine, a little re-shape has to be done on the frame
After that, the Engine could be fit with other parts
WIP : Daytona Cobra Coupe CSX2300 '65 Nurburgring
Very slow.
Now, working on the suspension
Glue the PE together piece by piece. Before using AA clue, using sand paper to polish it a little bit, so it makes PE glued stronger
The FRAME is done. Ready to paint. After that, put on engine and suspension. It would be easier since many test fitting have been done already. The only tricky thing is the ALIGNMENT
Now, working on the suspension
Glue the PE together piece by piece. Before using AA clue, using sand paper to polish it a little bit, so it makes PE glued stronger
The FRAME is done. Ready to paint. After that, put on engine and suspension. It would be easier since many test fitting have been done already. The only tricky thing is the ALIGNMENT
-
- Status: Offline