Re: Help with gloss paint
Posted: Thu Jun 16, 2022 2:12 pm
I have the same problem, there's just too much dust and dirt in the air. A few times I've seen a dust particle passing me by while spraying, heading for the model, as if it were a magnet, and landing on it
My solution so far is to sand away the particle using 12000 grit MicroMesh. That takes a bit longer because it's the finest grit, but the advantage is that you can polish straight after that, so the repair is fairly quick. Dust particles no longer stress me out too much.
Rob
My solution so far is to sand away the particle using 12000 grit MicroMesh. That takes a bit longer because it's the finest grit, but the advantage is that you can polish straight after that, so the repair is fairly quick. Dust particles no longer stress me out too much.
Rob