I'm not sure if this is a question or a warning.
My default choice of paints at present is the Tamiya LP range (like the spray cans but in a small Tamiya jar). I find the paints reliable and easy to spray.
However, a few days ago I sprayed the part shown (inner cockpit of Meng MP4/4) with gloss black and then a top coat of LP-9 clear. The whole of the exposed part gets covered in Carbon Fibre decals, so I just wanted a smooth surface to make the decals lay down properly.
Anyway, after leaving for a day to dry (at least 24 hours), I gave it a quick polish and wash. Left it to dry and came back to the result on the photo.
I can only assume that LP-9 is hygroscopic and that I need to leave it to dry for more than a day.
I've used LP-9 successfully many times before and I think the 'problem' this time was that the water must have laid on the part for a couple of hours and effectively it's acted as if it was soaking in water. With the other times I've exposed the LP-9 to water, I must have dried it off before the 'dulling effect' showed up.
It's no problem - I'll just strip the paint and start again.
Any comments would be read with interest - other than that, just beware on your own builds.
Best wishes
Malcolm
Tamiya LP-9 (clear)
-
- Best of the Rest
- Posts: 520
- Joined: Fri Oct 14, 2005 11:06 am
- Location: about 1985
- Status: Offline
Re: Tamiya LP-9 (clear)
Thanks, good to know.
Its always interesting to hear about the stumbling blocks rather than just - 'here it is finished'!
This prevents us making the same mistakes.
the other Malc.
Its always interesting to hear about the stumbling blocks rather than just - 'here it is finished'!
This prevents us making the same mistakes.
the other Malc.
-
- Constructors Champion
- Posts: 1316
- Joined: Mon Mar 06, 2006 9:38 am
- Your Name: C K
- Favorite F1 Team or Driver: Mercedes, McLaren, Williams
- Location: Canada
- Status: Offline
Re: Tamiya LP-9 (clear)
Hi Malcom,
I have a similar issue happened on acrylic clear. However, before I strip and paint again, the clear becomes clear again after I left the part for weeks. The water in the paint may be able to evaporate with time.
Wait so time before you strip it if you are not in a hurry. If it become clear again, it save you effect and we will al learn something.
I have a similar issue happened on acrylic clear. However, before I strip and paint again, the clear becomes clear again after I left the part for weeks. The water in the paint may be able to evaporate with time.
Wait so time before you strip it if you are not in a hurry. If it become clear again, it save you effect and we will al learn something.
C K
Canada
Canada
-
- Similar Topics
- Replies
- Views
- Last post
-
- 7 Replies
- 305 Views
-
Last post by OultonPark