Worked on adding wires and making wire loom for MP4/6 during past two weekends. User shrinking tube, super glue and thin
wires to make something that looks like what TopStudio instructions for 1/12 kit present. Not going to replicated all wiring that
they call out. And it's going to be way short of real car. But at least model will look a little "busier" in the end, hopefully. I've also
decided to make brake fluid lines on this model. That required from me to make a hole in front bulkhead, so I could route lines
from fluid cylinders to brake calipers and into cockpit, from where one line goes to rear splitter and rear calipers as well. Wiring
and plumbing on the engine is in progress.
Here are some photos. I think I need a better lighting. Not easy to make good photos of small details.