Ferrari 312 T4 MFH 1/20
-
Topic author - F2
- Posts: 70
- Joined: Wed Feb 04, 2015 7:31 am
- Status: Offline
Re: Ferrari 312 T4 MFH 1/20
sure will, very sexy car
-
Topic author - F2
- Posts: 70
- Joined: Wed Feb 04, 2015 7:31 am
- Status: Offline
Re: Ferrari 312 T4 MFH 1/20
Rear brake ducts cast in clear resin. I think this will add a nice touch to the car, when painted right...
-
Topic author - F2
- Posts: 70
- Joined: Wed Feb 04, 2015 7:31 am
- Status: Offline
Re: Ferrari 312 T4 MFH 1/20
Meanwhile at my bench... Tried to correct those plates under intake funnels, they will be cast in transparent resin for better representation
Re: Ferrari 312 T4 MFH 1/20
Good luck, you made a great start.
I remember from when I built this there was an issue with two pieces of PE that were intended for two opposite sides but two identical pieces were provided. I really can't remember what piece it was, though.
I remember from when I built this there was an issue with two pieces of PE that were intended for two opposite sides but two identical pieces were provided. I really can't remember what piece it was, though.
-
- F2 Champion
- Posts: 181
- Joined: Fri Dec 29, 2017 6:14 am
- Location: Toronto
- Contact:
- Status: Offline
Re: Ferrari 312 T4 MFH 1/20
With PE being flat, the issue you encountered couldn’t have been solved by flipping the piece over? Or there were etchings on the wrong side? No offence, just trying to understand.Moskie wrote:Good luck, you made a great start.
I remember from when I built this there was an issue with two pieces of PE that were intended for two opposite sides but two identical pieces were provided. I really can't remember what piece it was, though.
http://www.f1modelling.com
______________________________________________________________
PM me if you have an MFH 1/20 BT55 for sale (resin version, not metal)
______________________________________________________________
PM me if you have an MFH 1/20 BT55 for sale (resin version, not metal)
-
Topic author - F2
- Posts: 70
- Joined: Wed Feb 04, 2015 7:31 am
- Status: Offline
Re: Ferrari 312 T4 MFH 1/20
Thank you. there is provided samll PE fret with correct offset of those pieces.Moskie wrote:Good luck, you made a great start.
I remember from when I built this there was an issue with two pieces of PE that were intended for two opposite sides but two identical pieces were provided. I really can't remember what piece it was, though.
-
- Similar Topics
- Replies
- Views
- Last post