The F1M Forums

No worries. Just make sure it is fully cured. It will be trapped under different layer and can/will cause troubles when gassing out...

Thank you. This is what i need to know.

And is that background visible against black you painted? Because i want to use those decals too, but am afraid little bit...

Looks very very good. Did you encounter any problems with decals? Do they have black surroundings?

Tamiya acrylic clear yellow thined with lacquer thinner will do the job. It can be thicker than your usual thinning ratio

Good luck, you made a great start. I remember from when I built this there was an issue with two pieces of PE that were intended for two opposite sides but two identical pieces were provided. I really can't remember what piece it was, though. Thank you. there is provided samll PE fret with correct ...

Meanwhile at my bench... Tried to correct those plates under intake funnels, they will be cast in transparent resin for better representation

Rear brake ducts cast in clear resin. I think this will add a nice touch to the car, when painted right...

sure will, very sexy car