I just discovered a huge time saver when building the perfect parts brake disc set. I am building the 12th scale McLaren MP4/6. I finished the rear disks a few weeks ago and was not looking forward to starting the fronts. Building the hub nuts takes a long time using the PE nut/washer and a pin. There are 8 per disc. This past week I received my first order from Scale Hardware. I had to guess what size would work for 12th scale. One of the items I ordered was the 1.2mm hex nut with stud, nickel plated brass, #SMHN-12-N. They work great with the PP disc. There is enough of the stud sticking through the back that I could use the pe washer and nut. Instead of over 2 hours to build the disc, I took about an hour for both front discs. Hope this helps any of you with this add on for the McLaren or the Ferrari 641-2. I think sizes 1.0, 1.2, & 1.4mm would work best in 12th scale.
DS
Front of disc using the scale hardware bolts. Rear of disc using the PP pe over the SH shaft.
This picture show the rears using only the Perfect Parts PE bolts
